3500# GALVANIZED SPINDLE-LUBE 2X2 STRAIGHT BOAT TRAILER AXLE MOUNTS OVER SPRINGS WITH A TRACK GREATER THAN 85"

Item Number: ATSF35X

Unit Price: $229.95

In Stock

NON STOCK ITEM--MUST BE FABRICATED

Quantity

Bookmark This Page
Refer this page to a friend

Detailed Description

3500# Galvanized Spindle-Lube 2x2 straight boat trailer axle mounts over the leaf springs and has a track measurement greater than 85".

This trailer axle features the Spindle-lube ® hub lubrication system which allows you to grease the hubs without removing them from the axle. Unlike a bearing 'buddy', which only pumps grease into the front of the hub and can often be over-pumped and blow the grease seal, Spindle-lube trailer axles pump the grease to the back of the hub by a hole bored through the length of the spindle where it enters the hub just before the rear seal. The grease then moves forward filling the hub and bearings completely. When re-packing hubs with these trailer axles, the old grease will come out of the front of the hubs, around the tip of the grease gun. The grease should continue to be pumped until new grease comes out of the front of the hub. Then just replace the rubber plug into the dust cap and you are ready to go!!

This custom galvanized boat trailer axle is manufactured to the customer's track and spring center measurements. The track measurement is taken from the FACE of one hub (where the hub and the rim touch) to the FACE of the other hub. The spring center measurement is from center to center of the leaf springs on the trailer. [TIP - measure from the inside of one spring to the outside of the other spring for an exact spring center measurement.] There must be a minimum difference of 11" between the track and the spring center measurements in order for this axle to be built. Galvanized Spindle-lube boat trailer axles require 2 business days for fabrication time. When completing your order on-line, enter the track and spring center measurements into the fulfillment section of your order.

**THIS IS A NON-REFUNDABLE ITEM** PRODUCT SPECIFICATIONS: Capacity: 3500# Spindle size: 1 3/8" X 1 1/16" - Seal Seat: 1.71". Takes bearings - 68149 Inner / 44649 Outer - Seal - 171255 (Not included.). Brake flange: 4 hole. Box tube size - 1/4"x2"x2". Track measurement - more than 85". Axle position - over spring. Minimum difference between track and spring center - 11" Straight axle - spindle is welded directly into 2x2 box tube. ITEM INCLUDES: 1 - Axle 2 - 1" castle nuts. 2 - 1" Tab lock washers. 2 - Spindle-lube dust caps with rubber plugs.